spec no : www.shoulder.cn tel:0755-82916880 fax:0755-82916881 e-mail:info@shoulder.cn page 1 of 6 ? ? s s p p e e c c i i f f i i c c a a t t i i o o n n customer product ? frequency synthesizer model no ? hd m9030 prepared ? duchuangang checked ? houshihong approved ? charles d a t e ? 2008-05-21 ?? customer received: checked ? approved date ??? shoulder electronics limited
frequency synthesizer HDM9030 www.shoulder.cn tel:0755-82916880 fax:0755-82916881 e-mail:info@shoulder.cn page 2 of 6 ?? ?? ??? ?
frequency synthesizer HDM9030 www.shoulder.cn tel:0755-82916880 fax:0755-82916881 e-mail:info@shoulder.cn page 3 of 6 1. features small vollumeapplicable to surface mount technology low voltage work: +5v low phase noise working temperature-40 o c +85 o c cdma, wcdma, td-scdma wireless base station cdma, wcdma, td-scdma wireless repeater peer-to-peer communications equipment rfid
frequency synthesizer HDM9030 www.shoulder.cn tel:0755-82916880 fax:0755-82916881 e-mail:info@shoulder.cn page 4 of 6 4. electrical specification test conditions: reference freq.= 10mhz, reference level=1vp-p, reference p.noise=-145dbc/hz(fm=1khz) parameter min typ max units test results remarks frequency range 780 820 860 mhz step size - 100 - khz output power 0 3 5 dbm 100 hz - -78 -73 dbc/hz 1khz - -78 -73 dbc/hz 10 khz - -100 -96 dbc/hz 100 khz -125 -120 dbc/hz 1mhz -143 -133 dbc/hz output phase noise 4.75 5.0 5.25 volts vco power supply 4.75 5.0 5.25 volts pll - 30 35 ma vco supply current - 8 10 ma pll harmonic suppression: 2nd harmonic - -20 -15 dbc ref osc signal 10 mhz output impedance 50
frequency synthesizer HDM9030 www.shoulder.cn tel:0755-82916880 fax:0755-82916881 e-mail:info@shoulder.cn page 5 of 6 5. dimension pin out from pll pin application pin application 1 clock 9 vcc (vco) 2 data 13 rf out 3 enable 15 vcc (chip) 4 osc in 16 lock detect
frequency synthesizer HDM9030 www.shoulder.cn tel:0755-82916880 fax:0755-82916881 e-mail:info@shoulder.cn page 6 of 6 all other pins are ground symbol dimension(mm) symbol dimension(mm) a 21.00 the metal case is ground. 2. all half via contacts are plated thru from the pan on the top side to the pad on the bottom side of the board. 3. cross hatched areas are ground an d are covered with lp1 solder mask over bare copper.all contact areas are plated with sn63/pb37 solder. 4. substrate material:fr-4. 5. hdmxxxx represents the model number. ?? o c10s
|